Simple Guide for Hot Water Installation NJ Homeowners

Hot Water Installation NJOne of the most common repair jobs that are done in most homes is the installation of hot water systems. This installation procedure is easy to learn as it takes you from one step to another. Most of the hot water system appliances come with an installation guide that will provide you with a way of successfully installing the system. Professionals in hot water installation NJ would be the best way to go for this type of installation however; the procedure can still be performed by those that have some technical competence in home maintenance.

Hot Water Installation NJ Homeowner First Steps

You should use the drain valve to drain all the water out from the old heater. If the old heater was using gas you need to separate the draft hood from the vent pipe which should life off right after you have removed the sheet metal that has been holding it. You should always make sure that the pilot light is out and also make sure to disconnect the gas line and cap it.

The next step in hot water installation is removing the old heater from the pipes and you will have to be careful here since there is still a possibility of finding hot water in the pipes which may burn you. Pipe wrenches should be used in removing the hot water. After removing any hot water in the pipes, you can then remove the old water heater and dispose it.

Disposing of Your Water Heater

Here you will also need to consider that some local or state laws have guidelines of disposing of water heaters that you will need to adhere to. After this you can now start the actual installation of the new water heater. The new water heater should be carried careful from the shop to your home as there are several delicate parts that may break if you are not careful. You should then position the new water heater in a way that the piles will be able to reach it easily.

If you are going to use gas, ensure that the gas pipe will reach the heater easily as this will ensure that there will be no gas leaks. You can then proceed to connect the new water heater which should be easy and fast. You will need to follow the connections just the way you removed the old one. The third pipe should then be connected to the main water line. If you encounter any difficulties always refer to the manual instead of guessing and this is because connecting the pipes can be very complex at times.

You can do some testing before proceeding with the next step in hot water installation NJ home maintenance where you can turn on the water and if the cold water does not warm then you have to change the pipes. You can then connect the new water heater to the electricity or the gas line depending on which one you are using so the water can be heated and you can now use your water heater. If there are any problems that you can not solve you will have to call a professional.